HMI Audio Visual Sdn Bhd
131, Jalan Sutera,
Taman Sentosa ,
80150 Johor Bahru,
Johor, Malaysia.
+607-3311979
+607-3352504
+607-3352504
+607-3361359
+6016-7134999
(Hiu Chin Yang)
(Hiu Chin Yang)
Message Us
Branch
B-5-8, Plaza Mont Kiara,
Mont Kiara, 50480
Kuala Lumpur, Malaysia.
Hiu Musical Sound & Light
22, Sin Ming Lane
#06-76, Midview City,
Singapore, 573969.
Branch
B-5-8, Plaza Mont Kiara,
Mont Kiara, 50480
Kuala Lumpur, Malaysia.
Hiu Musical Sound & Light
22, Sin Ming Lane
#06-76, Midview City,
Singapore, 573969.
TF3
| Previous | 15 / 17 | Next |
Product Demo
Product Details:
General specifications
Analog input characteristics
*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
Analog output characteristics
*1.1: GND,2: HOT, 3: COLD
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms.
*All output DA converters are 24bit, 128times oversampling.
Indent Order
.jpg)
General specifications
| Sampling frequency rate | Internal | 48 kHz |
| Signal delay | Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz | |
| Fader | 100 mm motorized, Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders | |
| Total harmonic distortion | Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 , INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz) | |
| Frequency response | +0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT | |
| Dynamic range | 110 dB typ., DA Converter, 107 dB typ., INPUT to OMNI OUT, Input Gain=Min. | |
| Hum & noise level | Equivalent input noise | –128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter) |
| Residual output noise | –85 dBu, ST master off (Measured with an A-Weight filter) | |
| Crosstalk | –100 dB (Measured with a –30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min. | |
| Power requirements | 100–240 V 50/60 Hz | |
| Power consumption | 110 W | |
| Dimensions | W | 716 mm (28.2in) |
| H | 225 mm (8.9in) | |
| D | 599 mm (23.6in) | |
| Net weight | 17.0 kg (37.5lb) | |
| Accessories | Quick Guide, Power Cord, CUBASE AI download information | |
| Options | Expansion Card, Foot Switch (FC5) | |
| Others | Operating temperature range: 0–40 °C, Storage temperature range: -20–60 °C | |
Analog input characteristics
| Input Terminals | GAIN |
Load Impedance |
For Use With Nominal |
Input Level | Connector |
balanced / Unbalanced |
||
| Sensitivity*1 | Nominal | Max. before clip | ||||||
| INPUT1-24 | +66dB | 7.5KΩ |
50-600Ω‑ Mics or 600‑Ω Lines |
-82dBu (61.6V) | -62dBu (0.616mV) | -42dBu (6.16mV) |
Combo Jack (XLR-3-31 type *2 or TRS phone *3) |
Balanced |
| -6dB | -10dBu (245mV) | +10dBu (2.45V) | +30dBu (24.5V) | |||||
| ST IN 1,2 | — | 10kΩ‑ | 600‑Ω Lines | -30dBV (31.6V) | -10dBV (316mV) | +10dBV (3.16V) | RCA Pin Jack | Unbalanced |
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
Analog output characteristics
| Output Terminals |
Source Impedance |
For Use With Nominal |
GAIN SW | Output Level | Connector |
balanced / Unbalanced |
|
| Nominal | Max. before clip | ||||||
| OMNI OUT 1-16 | 75‑Ω | 600Ω‑ Lines | “+24dBu” position (default) | +4dBu (1.23 V) | +24dBu (12.3 V) | XLR-3-32 type *1 | Balanced |
| PHONES *3 | 100‑Ω | 40Ω‑ Phones | — | 3mW | 75mW | Stereo Phone Jack (TRS) *2 | Unbalanced |
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms.
*All output DA converters are 24bit, 128times oversampling.
Indent Order